Electric panels need updating water cooler motor
Electric panels need updating water cooler motor and monitoring from time to time. These
systems work effectively because they provide constant flow to the rest
of your home. However, you probably do not think about them until
something goes wrong.
- Have your system inspected every few years to look for potential wiring problems.
- If you notice signs of a problem, such as flickering lights, power
outages that occur frequently or even a smell of burning which you
cannot place, contact your service provider as soon as possible.
- If there is a faulty wire, or you find another problem, it is a good idea to seek out help right away.
The massive heart of your home's electric system needs regular attention
to keep it working, as it should. The electric panels present in a home
should receive regular updating. If you have yet to call a professional
to look at yours, be sure to do so. While these systems do last a long
time, they only do so if there is proper maintenance.Electric air compressors make many jobs a lot easier, but if you are in the market for one, sometimes the terms can be rather confusing. Here is a look at the meanings of some of the more common air compressor terms.
Electric air compressors are great for simple uses around the house. They can be used with a variety of tools, they often deliver more power than traditional power tools, and you never have to worry about a battery running out of juice!
But sometimes the lingo around electric air compressors can be rather confusing if you do not use one often, or if you are not very mechanically inclined. Here are just a few of the common terms you may come across when you are shopping around and looking at different electric air compressors.
After Cooler - a heat exchanger used for cooling air discharged from a compressor. The condensation that results from the cooling may be removed by a moisture separator following the after cooler.
Air Dryer - the device that removes the moisture from the compressed air after it has been cooled.
Capacity -the amount of air flow that electric air compressors deliver, usually expressed in cubic feet per minute (CFM). When purchasing an air compressor, make sure its capacity is enough to operate the tools you will use.
Check Valve - a valve which permits air flow in only one direction.
Compression Ratio - the ratio of the discharge pressure to the inlet pressure.
Constant Speed Control - a system in which the compressor is run continuously and matches air supply to air demand.
Cycle - the series of steps that a compressor with unloading performs: 1) fully loaded, 2) modulating (for compressors with modulating control), 3) unloaded, 4) idle. The amount of time for a compressor to complete one cycle is the cycle time.
Discharge Temperature - the temperature at the discharge flange of the compressor.
Full-Load - when electric air compressors operate at full speed with a fully open inlet and discharge, it is delivering maximum air flow.
Inlet Pressure - The actual pressure at the inlet flange of the compressor typically measure in pounds per square inch gauge (PSIG).
Load Time - the time period from when a compressor loads until it unloads.
Load / Unload Control - a control method which allows the compressor to run at a constant speed (while at full load or no load).
Pneumatic Tools - tools that are run using an air compressor.
Pressure Range - the difference between minimum and maximum pressures for electric air compressors.
Speed - the rpm of the electric air compressors drive or rotor shaft.
Unload (or no load) - compressor operation when no air is delivered because the intake is closed or modified to not allow inlet air to be trapped.
Valves - devices with passages for directing flow into alternate paths, or used to prevent flow.
These are just a few of the terms that may be helpful for you to understand when choosing which one of the many electric air compressors may be best for you. Also, make sure the tank size will support the type of jobs you will be doing. My husband is disappointed (yea,right!) that his 4 gallon tank, that he has owned for years, is not large enough to operate a sprayer, so he may have to purchase a larger one to get the job done right!
